Gamewell Honeywell GWF-7075, Руководство пользователя

Страница: 28 / 100

28
GWF-7075 Manual —
LS10147-002GF-E:G 10/5/2022
Control Panel Installation 5880 LED Driver Module
5. Press ENTER to bypass the next two screens. A screen similar to the one shown below will display.
6. Select options for the printer as needed for your installation. Most printers are parallel.
7. If you are using a serial printer, use the next screen to select serial port options as required for your printer. Refer to your printer manual
if you need more information.
4.9 5880 LED Driver Module
The 5880 is an LED driver board that can be used in a wide variety of applications, including as an interface with most customized floor plan
annunciator boards. The 5880 can drive up to 40 LEDs and has one PZT controller. The 5880 also has eight inputs for dry contact monitor-
ing. Up to 8 5880 modules can be added to the GWF-7075 System. The following sub-sections describe hardware installation. Refer to
Section 6 for programming information.
4.9.1 5880 Board Layout
Figure 4.16 is a picture of the 5880 board showing locations of screw terminals for connection to the panel and contact monitor wiring, pin
connectors for connecting LEDs, and a DIP switch for selecting an SBUS ID number.
Option Choices
Baud Rate: 75 - 19200
Data Bits: 5 - 8
Stop Bits: .5, 1, 2
Parity: None, Even, Odd
Table 4.8 Serial Printer Options
Select Yes if printer should be supervised for
Out-of-Paper and Offline conditions.
Select type of printer,
Parallel or Serial .
Monitor Printer=Yes
Output Port=Parallel
Event Logging=NO
More
Figure 4.15 Selecting Printer and Output Port Options
S- S+
A B
IN - 48 C+ IN - 47 IN - 46 C+ IN - 45 IN - 44 C+ IN - 43 IN - 42 C+ IN - 41
P1
P2 P3 P4
1
10 11
20 21
30 31
40
LED Out
LED Power
not used
LED Out
LED Power
not used
LED Out
LED Power
not used
LED Out
LED Power
not used
SBUS (ID#) Address
DIP switch
SBUS Connector
Figure 4.16 5880 Board Layout
dry contact inputs- supervised, power-limited