INSTRUCTIONS
INCLUDES:
Fountain, remote, USB charging cable
WARNING
• SEIZURES - People with photosensitive epilepsy can have seizures triggered by flickering
or flashing lights such as strobe or disco lights.
• Do not operate the product in water while it is plugged in. Serious and/or fatal injury
may result.
• To prevent damage to the pump, do not run the fountain out of water.
KEEP OUT OF REACH OF CHILDREN. THIS IS NOT A TOY.
NOTE
• The product projects light show approximately 15-20 feet (4.4-6.0 m) in diameter.
• Light show intensity will vary according to color, size and depth of your pool.
• Fountain has preset programming running at various heights.
GETTING STARTED
IMPORTANT: Before first use, the battery must be fully charged. This may take
up to 6 hours. When charged, the yellow light near charging port will turn off.
This product should be operated in at least 12 inches (30.5 cm) of water to get
the maximum water height. It is recommended to clean out the filter screen at
bottom of product periodically to ensure proper water flow.
1. Plug the charge cable into a USB port or any standard 5V 2A USB or better wall
adapter.
2. Remove the charging port plug on top of the product and plug the cable into the
port (the yellow light will turn on).
WARNING: Never turn on the product while it is charging. Always make sure the
product is thoroughly dry before charging.
3. When finished charging, (the yellow light will turn off), unplug the charge cable
from the charging port.
4. Replace the charging port plug, pressing it firmly into place so water does not seep
into the port when in use.
5. Place (do not throw or drop) product in water.
NOTE: Product shuts off after one hour (1) hour.
REMOTE
Remote comes with a button cell battery (lithium CR2032, 3 volts) installed.
Pull clear plastic tab at side of remote to enable battery connection.
NOTE: The remote will not work during the daytime. It emits IR (infrared)
waves. Sunlight also releases IR waves which interfere with the remote signal.
(English)
~ continued ~
IMPORTANT: The batteries in this product are permanently sealed in the product and cannot be removed or replaced. Attempting to remove
and/or replace the batteries will damage the product and void the warranty. The battery in the remote control is replaceable.
OPERATION USING CONTROL BUTTON
ON PRODUCT
Pressing the control button will change the mode
to the next mode.
Mode 1: Low fountain, no light show
Mode 2: High fountain, no light show
Mode 3: High fountain, light show 1
Mode 4: High fountain, light show 2
Mode 5: High fountain, light show 3
Mode 6: No fountain, light show 1
Mode 7: No fountain, light show 2
Mode 8: No fountain, light show 3
Off
OPERATION USING REMOTE
The remote must be pointed directly at the product for it to function.
Modes are in the same order as using the control button.
Press the
button for the fountain and the underwater light shows.
Press the
button for underwater light shows only (no fountain).
Charging Indicator
Charging Port/Plug
IR Eye for Remote
Infrared (IR) Eye
Control Button
Control Buttons
23600_R2A_IM_EN_11119.indd 1
11/11/2019 2:38:15 PM
