Game Composites GB1 GameBird, Руководство по обслуживанию

Страница: 165 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
32-5
Tailwheel General
A single tail-wheel with solid tire is pivot mounted to the tailwheel leaf spring.
The tail spring is mounted to the fuselage through three rubber bushings.
The tail-wheel is steered by compression springs connected via carabine clips to lugs on the rudder bracket.
The tailwheel components do not require regular maintenance.
If damaged or defective, units have to be replaced.
Tailwheel spring – GB1-3220-21-01
1. Jack up the tail of the airplane as described in 7-02
2. Use 5/8’’ wrench to remove Tailwheel assembly retaining bolt
3. Remove tail fairing
4. Disconnect linkage chains
5. Remove lock wire
6. Use 9/16’’ wrench to remove the 3 retaining bolts
7. Remove tail spring
8. Push stainless steel bushings out of rubber bushings
9. Remove rubber bushings
10. Clean all components
11. Inspect standard fasteners in accordance with 5-06 , No.1
12. Inspect landing gear legs in accordance with 5-06 , No.6
13. Assemble rubber bushings and sleeves into tail spring
14. Mount tail spring to airplane
15. Torque retaining bolts to 100 ” /lbs. / 10Nm
16. Lockwire all bolts
17. Reinstall tailwheel assembly
Signature
18. Check for correct installation
19. Reinstall tail fairing
20. Lower the airplane to the ground