Installation Instructions
1.
Install finial by screwing part (A) into part (B) (Fig. 1).
GS-106P
1. Use a drill to make two holes in the desired surface,
2. Place the white screw anchors into the drill holes, place the lamp in line with the holes and
screw down with the provided screws
.
Note:
There are specific types of screws for specific surfaces. If unsure of the appropriate type of
screw to use on your desired surface please consult a professional.
GS-106W
NOTE: For best results locate your solar lamp facing the south.
1. Remove the silver back bracket by removing the 2 screw caps on the front face of the
wall mount.
2. Screw the silver bracket onto the desired surface.
3.
Place lamp onto bracket and replace 2 wall mount screw caps
.
GS-106F
NOTE: If you are replacing an existing gas/electric post light, you must consult a certified
technician to cancel them before installation.
1. Position Part (D) on top of the existing 3” post and tighten it using the screws provided.
Replacing the Batteries
(After several years of use, the battery may need replacing).
1. Unscrew the two screw caps and detach part (B) from part (C). Make sure the ON/OFF
switch is in the OFF(O) position.
2. Unscrew the battery compartment screw, (Fig. 2) located on the silver reflector and
remove the compartment door.
3. Unclip the connector and remove the old battery. Make sure the new battery is high
quality 3.2V/1,500mAh Lithium
-ion
Rechargeable battery with connector.
4. Clip on new battery and install into the battery compartment. Screw back battery
compartment screw.
5. Reattach part (B) to part (C) and secure with the 2 screw caps.
WARNING
: Do not dispose of Li-Ion battery in the regular trash, municipal waste stream or by fire as
batteries may leak or explode. Do not open, short circuit, or mutilate batteries as injury may occur.
Preserve our environment by recycling Li-Ion batteries or disposing of them in accordance with local,
State and federal regulations. Do not mix old and new batteries.