1. Remove the EZ anchor plate (G) from the base
pole (F) by removing the cap nut, nut, and
washer from each of the three studs.
2. If Installing the lamp using the EZ anchor,
position the auger (H) where you want the
lamp to be. (If installing without the anchor,
skip to step 6b)
3. Using the turning bar (I), turn the auger (H) into the ground
clockwise.
Note:
For areas with hard dirt, moisten the ground with water to make
installation easier.
4. Make sure the auger goes in straight by using the level bubble at
the top. Stop once the ring is flush with the ground.
5. Place the EZ anchor plate (G) over the auger (H) and secure using
the large nut and bolt.
6. Secure the base pole (F)
a. If using the EZ anchor, slide the base
pole (F) over the EZ anchor plate (G).
Secure using the provided washer,
nut, and cap nut for each of the
three studs.
b. If not using the EZ anchor and securing
into concrete, using the base pole (F) as a
template, mark and drill three holes.
i. Place the anchors into the holes and secure the
base pole (F) by tightening the anchors.
7. Attach the middle pole (E) to the base
1.
Install the GS Solar LED Bulb into the Top (A).
2. Locate the operation switch on the underside of the Top (A).
3. Switch the lamp to either the Low or High setting according to your
preference:
Low = Softer light output and longer duration
High = Brighter light output
4. The lamp will operate automatically at dusk.
Assembly Instructions
Operation Instructions
Replacement Batteries and Bulbs are available at
www.gamasonic.com or via our Toll Free number: +1-800-835-4113
Your Lamp can use the following bulbs:
A50WW10W – included bulb with Warm White LEDs (2700K)
A50BW10W – bulb with Bright White LEDs (6000K)
F30WW05W – included Flame bulb with simulated flame LEDs
T45WW10W – Edison LED Bulb with Warm White LEDs (2700k)
Your Lamp uses the following battery:
GS32V15 – Li-Ion 3.2V/1500mAh
Replacement Parts
page 3
pole (F) and secure using the
three screws.
8. Attach the top pole (D) to the
middle pole (E) by twisting clockwise.
9. Attach the spacer pole (C) to the top pole (D) by
twisting clockwise.
10. Attach the fixture (B) to the spacer pole (C) by twisting
clockwise.
11. Insert the GS Solar LED bulb into the top (A) by twisting
clockwise. Be sure to hold the bulb by its base and not
the glass.
12. Turn the lamp on and secure the top (A) to the fixture
(B) using the provided screws.