Galvanic Applied Sciences 943-TGX-CE, Руководство по эксплуатации

Страница: 97 / 151

Revision 4 97 April 2020
5.4.1 Changing the Passwords
When logged into Update mode on the Factory Parameters page, there is a button marked
Change Password on the bottom of the page. When clicked, the Change Password dialog
box shown in Figure 66 appears.
Figure 66: Change Password Dialog Box
There are two passwords for the web GUI: the Operator password, which allows the user to
change parameters in the Configuration section of the analyzer (configuration parameters,
Modbus), and the Factory password, which is used to make changes to the factory
parameters. The
Change Password dialog box can be used to change either of these
passwords according to the procedure below:
1. To change the factory password, place a checkmark in the Factory Password
checkbox. To change the operator password, leave this checkbox unchecked.
2. Enter in the current password in the Enter Old Password.
3. Enter the desired new password twice in the Enter New Password (twice) fields.
4. Click on OK
5. If the current password is entered correctly, and the new password entered twice
matches, the dialog box will disappear, and the new password is now valid.
If the current password is entered incorrectly, or the new passwor
ds entered twice don’t
match, the error messages shown in Figure 67 will appear.
In either case, click on OK , then repeat the procedure taking care not to make the same
mistake.
5.5 Help Section
The Help section contains information that may be useful to the user for installation, operation,
and troubleshooting of the Model 943-TGX-CE analyzer.
5.5.1 Drawing Page
When the Drawing page is opened, a PDF showing generic drawings of the analyzer
exterior, interior, and electronic schematics is downloaded from the analyzer and displayed.
These drawings are also included in Section 9 of this manual.
Figure 67: Password Entry Error Messages