-8-
(Electrical Connections CONT’D)
Radio
PA
Thunder
Yelp
Wail
HF
Manual
Radio
Speakers 1
2
Manual
Horn
S1
S2
S3
S4
L1 L2 L3
PA
8
5
2
9
3
6
7
1
4
Electrical Connections For Lighting Control
RED
:
(8 AWG)
+12VDC Power
-
The two large red wires exiting the back
of the siren should be connected to
+12VDC
through a fuse rated for the
TOTAL current draw of ALL of the lights
controlled by this unit. They will supply
the power to the lights hooked up to the
9-pin connector.
You must connect
BOTH red wires.
9-Pin Connector
(REFER TO THE LIGHT WIRE DIAGRAM ON
THE NEXT PAGE FOR PROPER WIRE SIZES!)
The electrical connections for slide switch
outputs, and for the push button light
functions outputs are located on the
square 9-pin connector (part #SWH-49)
on the back of the siren.
Empty
(Pin 1)
Empty
:
(Pin 2)
Orange
:
(Pin 3)
L1 Output
– This power output is activated when the slide switch
is in the 1
st
, 2
nd
, or 3
rd
position.
Yellow
:
(Pin 4)
S4 Output
- Output power to lights controlled by S4 button.
Green
:
(Pin 5)
S2 Output
- Output power to lights controlled by S2 button.
Blue
:
(Pin 6)
S3 Output
- Output power to lights controlled by S3 button.
Violet
:
(Pin 7)
S1 Output
- Output power to lights controlled by S1 button.
Gray
:
(Pin 8)
L2 Output
– This power output is activated when the slide switch is
in the 2
nd
or 3
rd
position.
White
:
(Pin 9)
L3 Output
– This power output is activated when the slide switch is
in the 3
rd
position.
Testing
-
Test all siren and light functions after installation to assure proper
operation. Test vehicle operation to assure no damage to vehicle.
ButtonLabel Insertion
Once the wire connections have been made to S1
through S4, labels can be inserted into the switches.
The product is shipped with 30 different labels for these
push buttons. Select the desired label inserts
(provided). Insert the label into each button and tuck
it under the lip of the switch.
