635-SERIES HARDWARE M ANUAL
Chapter-Page
2-34
PART 4.2 4
(
REQUIRED
)
INSTALLING THE 635 DSI BOARD IN THE CONTROLLER
IF You are not installing a DSI, skip this section
1.
Loosen the stand-offs and mount Board (bracket) flush against the back wall of cabinet,
in next available slot.
DO NOT mount bracket on end of stand-off – See diagram below
NOTE: Board installs with components facing toward power supply.
2.
Tighten stand-offs on the bracket
,
to anchor the board firmly in position.
3.
Connect the Ribbon Cable
to the Data port (J4).
4.
Repeat instructions (beginning at 1) for each DSI Board you will be installing.
5.
DO NOT CONNECT BOARD TO THE POWER HARNESS UNTIL YOU HAVE FINISHED INSTALLING ALL BOARDS.
Figure 24
–
Installing a DSI Board with bracket against back of cabinet:
This diagram shows the installation of an interface board in the next available slot.
