635-SERIES HARDWARE M ANUAL
Chapter-Page
2-60
STEP 7. Set the Interface Board ID’s (DPI/DIO/DSI)
This step covers powering up, connecting to the data buss and setting the board ID for the
daughter Boards (i.e. DPI, DIO, DSI, etc.)
!
IMPORTANT:
BEST PRACTICE is to bring one board on at a time.
7.1 Apply power to the “Daughter” Boards (DPI/DIO/DSI)
635 NOTICE – 635 uses a binary dipswitch to set the Board ID and auto-update feature.
1.
Apply power to the Interface board
by plugging-in the oange connector from the wiring harness to
the board’s power connector. MAKE SURE THE POWER LED IS ON. It is located on the front edge
of board next to the power connector.
2.
Connect the Ribbon Cable
from the CPU data port to the daughter board data port. The data port is
on the same side of the board as the power connector.
3.
Press the RESET Switch (SW1) on this board
(not the CPU).
The reset switch is located next on the
front corner of the board – opposite corner from the power harness.
4.
Wait 10 seconds for the board to boot up.
