Gait up GAIT UP GO, Инструкция по эксплуатации

Страница: 22 / 51

Note: In case of lack of integrity of one or more components of the Gait Up GO medical device,
please immediately contact the customer support.
● Clean the Physilog6 sensor device and the clip accessories before using the device. See
section 5. Cleaning, Maintenance and Storage of the present document.
● Make sure that the Mobile Phone/Tablet is fully charged before starting an assessment
session.
●
Make sure that the Physilog6 sensor device is fully charged before starting an
assessment session.
● Do not operate the device while the Physilog6 sensor device is being charged.
● Open the Gait Up GO Mobile Application and connect it to the relevant Physilog 6
sensor device. Check that there are no connection issues. Refer to the section 4.4.2 of
the present document for more information.
● Position the sensor device into the clip accessories and check that the Physilog6
sensor device is firmly attached to the clip.
Note: In case of BLE connection issues, please contact your Healthacre Professional who has
prescribed you the medical device
A Participant must not wear more than one Physilog6 accessory on the body
at the same time. Do not operate several Gait Up GO on the same Participant
at the same time.
4.5. Operating the medical device
4.5.1 Opening the mobile application
Once the mobile application, installed in the smartphone/tablet, is opened, you will be able to
access the tests programmed by your healthcare professional. The main screen will show your
patient profile where the list of tests programmed and the Physilog6 sensor device
information screen are contained.
ENGLISH 22/51