Pub. 42004-550C
Elemec3
Console Manual
—Version 3
Page 99 of 109
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550C.docx
07/21
Load Test Offsets
The load test offsets define the pass/fail measurement range when the amplifier tests the loudspeaker(s).
The amplifier determines the speaker load is healthy when it measures a speaker load value that is within
the measurement range.
Load
—defines the amount of offset to add to the
calibrated speaker load value
to provide an
upper bound of the impedance range the amplifier uses to test the station’s speaker(s).
Load Offset −—
defines the amount of offset to subtract from the
calibrated speaker load value
to
provide a lower bound of the impedance range the amplifier uses to test the station’s speaker(s).
VLC Settings
VLC (volume level control) enables broadcasting audio at different volume levels than the volume level
configured for an event. The E3 controller broadcasts the current VLC level. The VLC level is
IDLE
when no event is occurring. This is the lowest VLC level possible. Create VLC levels on the
VLC
L
EVELS
tab of the
SP2
C
ONFIGURATION
A
SSETS
utility (see the VLC Levels section). Assign VLC
levels to events (see the Event Builder section) to configure the VLC priority level for the event. Assign
the VLC levels to SP2 stations on the VLC Settings Pane
Figure 114. VLC Settings Pane
Amplifier VLC Settings
VLC Amp Mode
—
OFF
/
LOWER THAN
/
GREATER THAN
/
EQUAL
operator used to compare the SP2
station’s VLC amplifier threshold to the event’s VLC threshold to control VLC while the event targets an
SP2 amplifier for the output.
VLC Amp Threshold
—Select a threshold level created on the
VLC
L
EVELS
tab in the
SP2
C
ONFIGURATION
A
SSETS
utility (see the VLC Levels section) or select
VLC
S
ETTINGS
to open the
VLC
L
EVELS
tab of the
SP2
C
ONFIGURATION
A
SSETS
screen.
VLC Amp Volume
—amplifier volume level set by VLC.
valid values: 0.008, 0.016, 0.032, 0.063, 0.125, 0.25, 0.5, 1, 2, 4, 9, 14, 18, 24, 30, 0 (watts)
600 Ohm VLC Settings
VLC 600 Ohm Mode
—
OFF
/
LOWER THAN
/
GREATER THAN
/
EQUAL
setting controls VLC while an event
targets 600-Ohm audio output.
VLC 600 Ohm Threshold
—Select a threshold level from the list of
VLC
L
EVELS
tab in the
SP2
C
ONFIGURATION
A
SSETS
utility (see the VLC Levels section) or select
VLC
S
ETTINGS
to open the
VLC
L
EVELS
tab of the
SP2
C
ONFIGURATION
A
SSETS
screen.
VLC 600 Ohm Volume
—600-ohm volume level set by VLC
valid values: 100, 200, 300, 500, 700, 775, 900, 1000, 0 (mV
RMS
)