46
English
6
Fill the milk carafe halfway with water and insert it into the machine.
7
Follow the instructions shown on the display to launch the descaling
procedure. This procedure takes about 25 minutes and consists of a descaling
cycle and a rinse cycle, performed with dispensing at regular intervals.
8
Once the descaling cycle has finished, rinse the water tank, the carafe and the
water circuit as per the displayed instructions.
9
Put back the filter into the water tank.
Note
: You can pause and resume the procedure at any time by pressing the
START/STOP
START/STOP
button.
Warning
: when the descaling cycle is running, the brew group cannot be removed.
Wait for the descaling process to finish, then remove the brew group.
Instructions to follow in case of descaling process
interruption
You can exit the descaling procedure by pressing the
ON/OFF
ON/OFF
button on the
control panel. If the descaling procedure is interrupted before completion, proceed
as follows:
1
Empty the water tank and wash it thoroughly.
2
Fill the water tank with fresh water up to the MAX level. Then switch on again
the machine. The machine will warm up and perform an automatic rinse cycle.
3
Before any brewing, we suggest you to run a manual rinse cycle as described
in the dedicated chapter.
Note
: if this procedure has not been completed, it will be necessary to carry out a
new descaling cycle as soon as possible.