Gaggenau WT262700, Инструкция по использованию и уходу / Руководство по установке

Страница: 32 / 56

32
en-us
Operating Instructions
NOTICE
If DR indicator lights up, check the drain hose and its
connections for restrictions and if the tank needs to
be emptied.
~
Page 45
3.
If required, select
U
(Low Heat) by pressing the button.
~
Page 39
4.
If required, select
5
(Wrinkle Block™) by pressing the
button.
~
Page 40
Indicator of program sequence
Gaggenau® dryers use an advanced control system
which continually monitors the laundry’s remaining
moisture.
The current state of the process and status of the
program is shown by indicator lights and 7-digit display.
Selecting a different program
If you have inadvertently started the wrong program, you
can change this as follows:
1.
Press
A
(Start/Pause) .
NOTICE
The drum will continue to rotate when the Cool Down
process is in progress, even if the program is paused.
The Cool Down process can be stopped at any time by
opening the door.
2.
Select another program and/or a different optional
program setting.
NOTICE
Do not change the program during the Cool Down
process.
3.
Press
A
(Start/Pause) . The new drying cycle starts
from the beginning.
Cancel program
If required, you can cancel the selected program:
1.
Press
A
(Start/Pause) .
2.
Press the center of the Program Selector to switch off
the appliance.
Program end
-
‹
- appears in the display area and the
A
(Start/Pause)
button indicator lamp is off.
After the program end, press the center of Program
Selector to switch off the appliance.
Removing laundry/switching the
appliance off
1.
Open the door and remove the laundry.
2.
Press the center of the Program Selector. Appliance
is switched off and dryer light goes out.
3.
Clean lint filter.
~
Page 42
4.
Close the door.
Tip: If the display panel switches off and the
A
(Start/
Pause) button indicator is blinking at the end of a
program, the Energy-saving mode is active. To activate
the display, press any button.
~
Page 11