Gaggenau WM262700, Инструкция по использованию и уходу / Руководство по установке

Страница: 30 / 56

30
en-us
Operating Instructions
Selecting a different program
If you have inadvertently started the wrong program, you
can change this as follows:
1.
Press
A
(Start/Pause) .
2.
Select another program.
3.
Press
A
(Start/Pause) . The new cycle starts from the
beginning.
Pausing/Adding a garment to the cycle
Pausing the wash cycle can be useful for several
purposes.
e.g. for soaking
~
Page 40
Press
A
(Start/Pause) . The indicator lamp
A
is blinking.
Wash load will soak in water until continued by pressing
A
(Start/Pause) .
For adding a garment after the cycle begins.
1.
Press
A
(Start/Pause) . Door will unlock when safe to
do so.
2.
Open door carefully and add or remove laundry item.
NOTICE
You can do this as long as the
A
(Start/Pause)
indicator flashes and it is safe to do so.
3.
Close door.
4.
Press
A
(Start/Pause) .
The cycle continues.
NOTICE
If the cycle is paused but the door will not unlock it could
be for safety reasons (high water level, water temperature
or drum speed).
Cancel program
For cycles with a high temperature:
1.
Press
A
(Start/Pause) .
2.
Cool the laundry off: Select RINSE .
3.
Press
A
(Start/Pause) .
For cycles with a low temperature:
1.
Press
A
(Start/Pause) .
2.
Select SPIN/DRAIN and 0 (Spin Speed) option to No
Spin .
3.
Press
A
(Start/Pause) .
Program end
-
‹
- appears in the display field and the
A
(Start/Pause)
button indicator lamp is off.
NOTICE
If this symbol Å appears in the display, the washer has
detected too much foam and it automatically adds an
additional rinse cycles to remove the foam.
Use less detergent the next time you run the washer with
the similar load.
Removing laundry/switching the
appliance off
1.
Open the front door of the washer and remove the
laundry.
2.
Press the center of Program Selector to switch off the
appliance.
3.
Turn off the water taps.
NOTICE
▯
Do not leave any laundry in the drum. It can shrink or
become discolored by the next laundry load.
Note:
▯
Remove any remaining items from the drum and
rubber gasket.
▯
Leave the front door and detergent drawer open so
that any remaining water can dry.
▯
Always wait for the end of the cycle before switching
off the appliance; otherwise the appliance may still be
locked. If locked, switch the appliance on and wait
until it unlocks.
▯
If the display panel switches off and the
A
(Start/
Pause) button indicator is blinking at the end of a
program, the Energy-saving mode is active. To activate
the display, press any button.