Gaggenau WM262700, Инструкция по использованию и уходу / Руководство по установке

Страница: 23 / 56

23
Installation instructions
en-us
Transporting the washer
Before transporting the washer
1.
Disconnect the washer power cord from the wall
outlet.
2.
Turn off the water supply to the washer.
3.
Disconnect water supply lines from the tap.
4.
Disconnect the drain hose from the drain location.
5.
Install the transport bolt assemblies as shown in the
following images.
Remove the transport bolt hole covers
1.
Remove all four transport bolt hole covers.
2.
Pull the tip of the arrow on the cover out slightly to
disengage the locking tab.
3.
Rotate the cover counterclockwise to remove. Repeat
for all 4 transport bolt hole covers.
Insert the transport bolt assemblies
1.
Each assembly consists of a plastic bushing and a
bolt that extends through the bushings. Unscrew the
bolt until the threaded end is flush with the end of the
plastic bushing.
2.
Insert the transport bolt and bushing assembly as
shown. The metal housing slides around the bolt
through the slot in the plastic bushing as the bushing
is slid into place. The open part of the bushing slot
should be facing the direction shown to allow the
assembly to slide fully into place.
3.
When the bolt is in place screw it in until the bolt
threads engage the drum. Double check and ensure
bolts are screwed into threaded holes and not into
cracks or crevices. Repeat the process for all 4
transport bolt assemblies before tightening any all the
way. Complete tightening all 4 bolt assemblies until
they are each snug in place.