Gaggenau VL 200 120, Инструкция по эксплуатации

Страница: 9 / 48

9
Operating the appliance
en
Operating the appliance
Operating the appliance
Switching on
Automatic mode, three fan settings, intensive mode
Ž
and the intermittent ventilation system
μ
are available
for extraction.
Push in the control knob and turn it clockwise to the fan
setting you require.
The illuminated ring behind the control knob will light
up.
Switching off
Turn the control knob anti-clockwise to position 0.
Intensive setting
Activate intensive mode if strong odours or large
amounts of steam are produced. In this mode, the
appliance operates at its maximum fan setting for a
short time. After approx. 6 minutes, the appliance will
automatically switch back to fan setting 3.
Switching on
Push in the control knob and turn it clockwise to the
Ž
position.
Intensive mode is activated. The illuminated ring behind
the control knob will go out briefly and then light up
orange. A signal tone will sound.
Note: Intensive mode runs for 6 minutes. Once this time
has elapsed, the appliance will switch back to fan
setting 3. A signal tone will sound. The control knob
remains in position
Ž
. The illuminated ring behind the
control knob will go out briefly and then light up orange.
Switching off
Turn the control knob anti-clockwise to position 0.
Intermittent ventilation
With intermittent ventilation, the fan automatically
switches to fan setting 1 for 6 minutes every hour.
Switching on
Push in the control knob and turn it clockwise to the
μ
position.
Intermittent ventilation is activated. The illuminated ring
behind the control knob will be lit orange while the
ventilation system is switched on.
Switching off
Turn the control knob anti-clockwise to position 0.
Automatic mode
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. The
appliance selects the appropriate fan setting
automatically.
Switching on
Push in the control knob and turn it clockwise to the
<
position.
Automatic mode is activated.
The optimum fan setting 1, 2 or 3 is set automatically
using a sensor. The illuminated ring behind the control
knob will be lit orange while the ventilation system is
switched on.
Automatic mode can run for a maximum of 8 hours.
Switching off
Turn the control knob anti-clockwise to position 0.
Saturation display
When the metal grease filter or the activated charcoal
filter (only in air recirculation mode) are saturated, a
signal sounds after the appliance has been switched off
and the illuminated ring on the control knob flashes:
▯
Metal grease filter: 3 times white, slow flashing
▯
Activated charcoal filter: 6 times white, rapid
flashing
Do not wait any longer to clean the metal grease filters
or replace or regenerate the activated charcoal
filters.
~
"Cleaning and maintenance" on page 11