Gaggenau VI 414 103, Инструкция по эксплуатации

Страница: 25 / 32

25
Cookware test
en
Resetting connection
You can reset the connections you have saved for your
home network and extractor hood at any time.
1 Push in any control knob and turn it anti-clockwise
to the
Ž
position.
2 Turn the control knob clockwise to position
ª
or
¹
.
3 Turn the control knob anti-clockwise to position 0 .
The illuminated ring on the control knob lights up
blue.
4 Turn the control knob clockwise to position 2 .
¥“†
lights up on the control panel. After
30 seconds, the connection is reset and the
illuminated ring on the control knob flashes. The
connection is reset once
š‹¯“
lights up on the
control panel and the illuminated ring on the control
knob lights up green.
t
Cookware test
Cookware test
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1 Fill the pan with approximately 200 ml water and
place it in the middle at room temperature.
2 Go to the basic settings and select the
™„
setting.
‹””
will be lit.
3 Touch the
@
or
A
symbol.
‹¯
will be lit. An audible
signal will sound and the hotplate indicator will be
lit.
The function has now been activated.
¥—¯
will be lit. After a few seconds, the hotplate display
will show the results for the quality and speed of the
cooking process.
Check the result using the following table:
To activate the function again, select the
@
or
A
symbol.
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.