Gaggenau VG415315SG, Инструкция по эксплуатации

Страница: 33 / 36

Installing the appliance (Fig.3a)
1. Insert the end of the connection cable for the control knob into
the female connector on the underside of the appliance. The
male connector must snap into place.
2. Insert the appliance evenly into the cut-out. Push it down
firmly into the cut-out.
Note: The appliance must sit fast in the cut-out and must not
be able to move around (e.g. during cleaning). If the width of
the cut-out is at the upper tolerance limit, secure batten to the
sides of the cut-out if necessary.
3. Connect the appliance to the power and gas supply and test
for correct functioning. There might be an air pocket in the
gas supply line if the appliance switches off. Turn control
knobs off and switch on again. Repeat until burner ignites.
Only for installation flush with surrounding
surfaces (Fig.3b)
Note: Make sure that everything is working correctly before grouting.
Grout the surrounding gap with a suitable temperature-resistant
silicone adhesive (e.g. OTTOSEAL ® S 70). Smooth the seal joint
with a smoother recommended by the manufacturer. Follow the
instructions for the silicone adhesive. Do not use the appliance until
the silicone adhesive is completely dry (at least 24 hours, depending
on the room temperature).
Caution!
Using unsuitable silicone adhesive on natural stone work surfaces
may cause permanent discolouration.
Gas connection (Fig. 4)
The gas connection must be located in a position where the stop tap
is accessible.
According to the Gas Safety Ordinance of Hong Kong, any gas
installation works including the installation of appliances and
connection tubing, must be undertaken by registered gas
installers who are registered for that appropriate classes and be
employed by registered gas contractors.
Use approved gas tubing bearing EMSD approval marking
(example : 機電工程 機電工程署批准 署批准 EMSD APPROVAL GTXXXX) for
connection to appliances or other appropriate methods
accepted by EMSD.
Using R½'' (for appliance side) connection elbows provided, connect
the appliance to the gas tubing. The gas tubing must be routed so
that it does not come into contact with moving parts of the kitchen
unit (e.g. drawers).
Electrical connection
Check that the appliance has the same voltage and frequency as the
electrical installation system.
The hob is delivered with a mains cable, with or without plug,
depending on model.
Only connect the appliance to sockets which have been fitted and
earthed according to regulations.
The appliance corresponds to type Y: the mains connection cable
must only be replaced by the after-sales service. Check the cable
type and minimum cross section.
Technical data
Gas type: Hong Kong Town Gas (15 mbar)
Total connected load VG41531
5
SG: 6.5 kW
Voltage and frequency: 220-240 V, 50/60 Hz
Electrical nominal power: 25 W
Removing the appliance
Disconnect the appliance from the power and the gas supply. For
flush-mounted appliances, remove the silicone joint. Push out the
appliance from below.
Caution!
Damage to appliance! Do not lever out the appliance from above.