Gaggenau RF 222, Руководство пользователя, Страница: 30 / 80

30
en
Faults – what to do?
3
Faults – what to do?
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the fault yourself.
--------
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
~
"Switching off and disconnecting the appliance"
on page 25
If the temperature is too warm, check temperature again after
a couple of hours.
If the temperature is too cold, check temperature again on the
following day.
Displays do not illuminate.
The mains plug has not been inserted properly. Connect the mains plug.
The fuse has tripped. Check the fuses.
The power has failed. Check whether the power is on.
Display indicates “E…”.
Electronics have detected a fault. Call the customer service.
~
"Customer service" on page 31
A warning signal sounds and the
Ú
button is lit.
Press the
Ú
button. Alarm is switched off.
Appliance door is open. Close the appliance door.
Ventilation openings have been covered. Clear ventilation openings.
Large quantities of fresh food were placed in the appliance. Do not exceed max. freezing capacity.
Display flashes, warning signal sounds and button
Ú
is lit.
Press the
Ú
button. Alarm is switched off.
Appliance door is open. Close the appliance door.
Ventilation openings have been covered. Clear ventilation openings.
Large quantities of fresh food were placed in the appliance. Do not exceed max. freezing capacity.
Display flashes.
The temperature in the freezer compartment was too warm. When button
Ú
has been pressed, the warmest temperature
reached in the freezer compartment is displayed for 5 sec-
onds. Press the
Ú
button. The display stops flashing.
Appliance is not cooling, display and lighting are lit.
Demo mode switched on. Start the appliance self-test.
~
"Customer service"
on page 31
When the programme has ended, the appliance switches
over to normal operation.