Installation and connection
en
51
Removal
Also observe the sequence of worksteps here.
1.
Disconnect the appliance from the power supply.
2.
Turn off the tap.
3.
Undo the waste water and drinking water connection.
4.
Loosen fastening screws for the furniture parts.
5.
If fitted, remove the base panel.
6.
Pull out the appliance, carefully pulling the hose
behind.
Transporting
Empty the dishwasher and secure loose parts.
Drain the appliance according to the following steps:
1.
Turn on the tap.
2.
Open the door.
3.
Switch on ON/OFF switch
(
.
4.
Select programme with the highest temperature.
The estimated programme duration is indicated on
the display window at the top
@
.
5.
Press START button
)2
.
6.
Close the door.
Programme sequence starts.
7.
Open the door after approx. 4 minutes.
8.
Press START button
)2
until “Program was
terminated”/“Ready in one minute.” is indicated at
the top of the display window
@
.
9.
Close the door.
10.
Open the door after approx. 1 minute.
The display window at the top
@
indicates;
“Finished”.
11.
Switch off ON/OFF switch
(
.
12.
Turn off the tap, disconnect supply hose and drain
water.
Note:
Transport appliance upright only. This prevents
residual water from running into the machine control
and damaging the programme sequence.
Protection against frost
Protection against frost (Emptying the appliance)
If the appliance is in a room where there is a risk of
frost (e.g. holiday home), empty the appliance
completely (see Transportation).
6XEMHFWWRFKDQJHV
