en
Installation and connection
50
Warm water connection *
Warm water connection
* depending on the features of your dishwasher
The dishwasher can be connected to cold or hot water
up to max. 60 °C. Connection to hot water is
recommended if the hot water can be supplied by
energetically favourable means and from a suitable
installation, e.g. solar heating system with circulation
line. This will save energy and time. The “Hot water”
setting allows you to adjust your dishwasher optimally to
operation with hot water. It is recommended to have a
water temperature (temperature of the incoming water)
of at least 40 °C and no more than 60 °C. It is not
recommended to connect the appliance to hot water if
the water is supplied from an electric boiler.
To change the setting:
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Press Info button
{8
for 3 seconds until the
following text is indicated on the display window at
the top
@
:
Scroll with
< >
Set with
- +
Leave with Setup 3 sec.
4.
Keep pressing the button
>
)R
until water
connection appears of the display window at the top
@
.
5.
Make the setting with setting buttons
+ -
`
.
6.
Press and hold the Info button
{8
for 3 seconds.
The chosen setting has now been stored.
Electrical connection
▯
Connect the appliance to an alternating current only,
ranging from 220 V to 240 V and 50 Hz or 60 Hz via
a correctly installed socket with protective earth
conductor. See rating plate for required fusing
9J
.
▯
The socket must be near the appliance and freely
accessible following installation.
If the plug is not freely accessible, an allpole
disconnector with a contact opening of at least 3 mm
must be fitted on the installation side to satisfy the
relevant safety instructions.
▯
The connection may be modified by technicians only.
▯
A power cord extension may be purchased from
customer service only.
▯
Use only a residual current operated circuit-breaker
which features the symbol
‚
. Only this extension
guarantees compliance with the currently valid
regulations.
▯
The appliance features a water damage protection
system. Please note the system will function
only
when the power supply is connected.
