en
Operating the appliance
34
AquaSensor *
AquaSensor
* depending on the features of your dishwasher
The Aqua sensor is an optical measuring device (light
barrier) which measures the turbidity of the rinsing
water.
The AquaSensor is used according to the programme. If
the AquaSensor is active, “clean” rinsing water can be
transferred to the next rinse bath and water
consumption can be reduced by 3–6 litres. If
the turbidity is greater, the water is drained and
is replaced with fresh water. In the automatic
programmes the temperature and running time can also
be adjusted to the degree of soiling.
Zeolith drying
¼
Zeolith drying
:
Warning – Risk of burns from touching the blow
opening
1R
!
Never touch the blow opening. The blow opening
becomes hot and, furthermore, any damage will result in
a chargeable callout by customer service.
Caution!
Please ensure that the intake opening
1J
is not
obstructed and do not place any temperature-sensitive
utensils in the lower basket at the rear right side above
the blow opening
1R
.
The appliance features a Zeolith container. Zeolith is a
mineral which can store moisture and heat energy
and release them again.
During the washing step this heat energy is used to dry
the mineral and heat up the rinsing water.
During the drying phase moisture from the rinsing
compartment is stored in the mineral and heat energy
is released. This released heat energy is blown into
the rinsing compartment with dry air. This accelerates
and improves drying.
These processes therefore save a great deal of energy.
Time display
The running time is determined during the programme
by the water temperature, the number of utensils as well
as the degree of soiling and may vary (depending on the
selected programme). You can change the time display
in time or hours/minutes so that the remaining running
time of the rinsing progamme appears in the display
window “Ready at” (for example 15:20 hours) or “Ready
in” (for example 3:25).
Sensor setting
The programme sequence is optmised in Auto
programmes with the aid of sensors. The sensors adjust
the programme strength of Auto programmes depending
on the amount and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard:
This setting is ideal for a mixed load and
heavily soiled utensils, but also saves energy and water.
Sensitive:
This setting adjusts the programme strength
for the effective removal of food remnants, even if the
amount of soiling is low. The energy and water
consumption is adjusted accordingly.
Very sensitive:
This setting adjusts the programme
strength for difficult conditions of use, for example
firmly dried on food remnants. This setting is
recommended if using biological or eco detergents
which contain lower amounts of active agents. The
energy and water consumption is adjusted accordingly.
extraDry
The final rinse uses a higher temperature which
improves the drying result. The running time may
increase slightly. (Caution if utensils are delicate!) You
can switch the extraDry function on or off.
