Gaggenau DF480801, Инструкция по применению

Страница: 35 / 76

Rinse aid system
en
35
¡
The water hardness is 0 - 8 °E.
You do not need to use special
salt.
1.
Press ⁠.
2.
To open the basic settings, press
for approx. 3 seconds.
3.
Press repeatedly until the display
shows "Water hardness".
4.
Press or repeatedly until the
display shows 0 - 8.
5.
To save the settings, press for
approx. 3 seconds.
a
The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Rinse aid system
12 Rinse aid system
Rinse aid system
12.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the display shows "Please add
rinse aid. ", add rinse aid. Only use
rinse aid for domestic dishwashers.
1.
Press the catch on the lid of the
dispenser for rinse aid and lift
⁠.
1
2
2.
Add rinse aid up to the max mark.
max
3.
If rinse aid spills out, remove it
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
4.
Close the lid of the dispenser for
rinse aid.
a
The lid clicks into position.
12.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
1.
Press ⁠.
2.
To open the basic settings, press
for approx. 3 seconds.
3.
Press repeatedly until the display
shows "Rinse aid dispenser".
4.
Press or repeatedly until the
right amount of rinse aid has been
set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
5.
To save the settings, press for
approx. 3 seconds.