Gaggenau DF480161CN, Инструкция по эксплуатации

Страница: 13 / 48

Water softening system / special salt
en
13
Water softening system / special salt
Water softening system / special salt
To ensure good rinsing results, the dishwasher
requires soft water, i.e. water which is low in lime,
otherwise limescale will be deposited on the utensils
and interior container. Tap water above 7° dH
(1.2 mmol/l) must be softened. The water is softened
with special salt (regeneration salt) in the water
softening system of the dishwasher. The setting and
therefore the required amount of salt depends on the
degree of hardness of your tap water (see following
water hardness table).
Water hardness table
Adjusting the water softening system
The amount of salt dispensed can be set from 0 to 62 °E.
Salt is not required at the set value 0-8 .
Set the softening system as follows:
1.
Ask your local water utility company for the water
hardness value of the tap water.
2.
Required setting can be found in the water hardness
table.
3.
Open the door.
4.
Switch on ON/OFF switch
(
.
5.
Press Info button
{ 8
for 3 seconds until the
following text is indicated on the display window at
the top
@
:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
6.
Keep pressing button >
)*
until the water hardness
is indicated on the display window at the top
@
.
7.
Make the setting with setting buttons + -
X
.
8.
Press and hold the Info button
{8
for 3 seconds.
The chosen setting has now been stored.
:DWHU
KDUGQHVV
YDOXHƒ(
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW