en
Basic operation
14
9.7 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
▶
Press .
a
The intensive mode is switched on.
a
lights up.
a
After approx. six minutes, the appliance switches
back to the power level .
9.8 Switching off intensive mode
▶
Press .
a
The intensive mode is switched off.
9.9 Automatic mode with sensor control
In automatic mode, a sensor in the appliance detects
the intensity of the cooking odours and roasting
odours. The optimal fan speed is automatically
switched on depending on the sensor sensitivity set-
ting. If the sensor control reacts too weakly or too
strongly, you can change the setting for the sensor
sensitivity.
Switching on automatic mode with sensor
control
▶
In the basic settings, define the setting for the auto-
matic mode.
a
The optimal power level is automatically set using a
sensor.
Switching off automatic mode with sensor
control
▶
Press until another power level or lights up.
a
Automatic mode with sensor control is switched off.
9.10 Fan run-on
The fan run-on only starts if at least one cooking zone
has been switched on for at least one minute. After you
switch off the cooking zone, the ventilation system con-
tinues to run for a few minutes in order to remove any
cooking vapours. The ventilation system then switches
off automatically.
When you switch off all cooking zones, and light
up. The fan run-on is switched on.
When you switch on a cooking zone, the fan run-on is
switched off.
Switching off the fan run-on
▶
Use to set the required power level .
a
This immediately stops the fan run-on.
9.11 Switching on intermittent ventilation
For intermittent ventilation, the appliance switches on
the ventilation for six minutes per hour each time.
Requirement:
A power level is selected.
▶
Press or repeatedly until lights up.
a
The intermittent ventilation is activated.
Note:
If you switch off the appliance, the intermittent
ventilation is switched on.
9.12 Switching off intermittent ventilation
▶
Use to set the required power level .
a
The intermittent ventilation is switched off.
9.13 Deactivating demo mode
The appliance does not heat up in demo mode. If
is lit up, demo mode is activated.
1.
Disconnect the appliance from the mains power
supply.
2.
Wait 30 seconds.
3.
Reconnect the appliance.
‒
Deactivate the demo mode within the next
three minutes.
4.
Turn one of the control knobs anti-clockwise to .
5.
Turn the same control knob clockwise to .
6.
Turn the same control knob anti-clockwise to .
a
The illuminated ring on the control knob lights up
yellow.
7.
Turn the same control knob clockwise to .
a
lights up.
a
The illuminated ring on the control knob lights up
green.
8.
Wait approx. five seconds.
a
lights up.
a
The illuminated ring on the control knob lights up
yellow.
a
The demo mode is deactivated.
9.14 Changing the colour of the illuminated
ring
Note:
The illuminated ring on the control knob lights up
orange during operation. You can choose between a
lighter and a darker orange.
1.
Carry out the following operating steps without inter-
ruption.
2.
Push in the control knob and turn it anti-clockwise to
the position.
Leave the control knob pushed in.
3.
Turn the control knob clockwise to .
Leave the control knob pushed in.
4.
Turn the control knob anti-clockwise to .
a
lights up.
a
The illuminated ring on the control knob lights up
yellow.
a
The menu for changing from orange is open.
5.
Push in the control knob and turn it clockwise to .
