Gaggenau CV282110, Инструкция по эксплуатации

Страница: 45 / 52

45
Cleaning
en
After power is turned off,
” ” — ––
or
” ’•‘¯ ®“
lights.
1 Hold
}
symbol for at least 4 seconds until a beep
sounds.
The saturation indicator for the metal grease filter is
reset.
2 If
” ’•‘¯ ®“
is lit, press symbol
}
again for at
least 4 seconds until a beep sounds.
The saturation indicator for the activated charcoal
filter is reset.
Cleaning the overflow container
Notes
– Make sure that the supply to the overflow container
is not blocked. Remove any objects that have
entered the appliance once it has cooled down. To
do this, take the filter cover off and take the metal
grease filter and the container out.
– Any liquid entering the appliance from above will be
collected in the overflow container. Unscrew the
overflow container and empty it. Take the housing
cover off if necessary.
1 Unscrew the overflow container with both hands.
Notes
–
Hold the overflow container level to prevent
liquid from leaking out.
–
Take the housing cover off if necessary.
2 Empty the overflow container and rinse it out.
3 Clean the overflow container before screwing it
back into place.
4 Refit the housing cover.
Twist knob
The twist knob is best cleaned using lukewarm soapy
water. Do not use harsh or abrasive cleaning agents. Do
not clean the twist knob in the dishwater or using
rinsing water. This may damage it.
Wireless temperature sensor
Temperature sensor
Clean the temperature sensor with a damp cloth. Never
clean it in the dishwasher. Do not immerse it in water or
clean it under running water.
Remove the temperature sensor from the saucepan after
cooking. Store it in a clean, safe place (such as in its
packaging) away from sources of heat.
Silicone patch
Clean and dry before attaching to the temperature
sensor. Dishwasher safe.
Note: Cookware with the silicone patch must not be left
to soak for long periods in soapy water.
Temperature sensor window
The sensor window must always be clean and dry.
Proceed as follows:
▯
Remove dirt and oil splatters regularly.
▯
Use a soft cloth or cotton buds and window cleaner
for cleaning.
Notes
– Do not use abrasive cleaning agents such as
scouring pads, scrubbing brushes or cream
cleaners.
– Do not touch the sensor window with your fingers.
This may make it dirty or scratch it.