Gaggenau CV282110, Инструкция по эксплуатации

Страница: 40 / 52

40
en
Cookware test
Cookware test
Cookware test
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1 With the cookware still cold, fill it with approx.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely
matches that of the base of the cookware.
2 Go to the basic settings and select the
™ˆ
setting.
3 Touch the control panel.
A
will flash on the hotplate
display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear in the hotplate display.
Check the result using the following table:
To reactivate this function, touch the settings range.
Notes
– If the diameter of the hotplate used is much smaller
than the diameter of the cookware, it is likely that
only the middle of the cookware will heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
– You can find information on this function in the
section entitled
~
"Basic settings"
– You can find information on the type, size and
positioning of the cookware in the section entitled
~
"Induction cooking"
h
Power manager
Power manager
You can use the power manager to set the total power of
the hob.
The hob is preset at the factory. Its maximum
performance is specified on the rating plate. You can
use the power manager to change the value in
accordance with the requirements for the relevant
electrical installation.
In order not to exceed this set value, the hob
automatically distributes the power available between
the cooking zones that are switched on.
As long as the power manager function is activated, the
output of a cooking zone may temporarily fall below the
nominal value. If a cooking zone is switched on and the
power limit is reached,
¬
appears in the heat setting
display for a short time. The appliance automatically
regulates and selects the highest possible power level.
For more information about how the total power of the
hob is changed, see section
~
"Basic settings"
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.
X|
É
Y| [|
\|
Z|