Gaggenau CV 282, Инструкция по эксплуатации

Страница: 42 / 64

42
en
Wireless temperature sensor
Detection failed: Five beeps will sound. The
¨
symbol immediately changes from orange to white
and the cooking sensor indicators on the cooking
zones go out.
▯
The cooking functions are made available as soon
as the wireless cooking sensor has been connected
to the control panel correctly.
▯
If there is a fault with the wireless cooking sensor,
the connection may not be established correctly for
the following reasons:
– Bluetooth communication error.
– You have not pressed the
¨
symbol on the
cooking sensor within 30 seconds of selecting
the cooking zone.
– The battery in the wireless cooking sensor is
almost flat.
Reset the wireless cooking sensor and repeat the
connection procedure.
▯
If there are problems with the connection due to a
transmission error, repeat the connection
procedure.
If a connection cannot be established, inform the
after-sales service.
Resetting the wireless temperature sensor
1 Touch and hold the
¨
symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the
LED lights up for the third time, it will start to reset
the temperature sensor. At this point, you will need
to lift your finger off the symbol.
Once the LED goes out, this means that the
wireless temperature sensor has been reset.
2 Repeat the connection procedure from point 2.
Cleaning
Do not clean the wireless temperature sensor in the
dishwasher.
Temperature sensor
Clean the temperature sensor with a damp cloth. Never
clean it in the dishwasher. Do not immerse it in water or
clean it under running water.
Remove the temperature sensor from the saucepan after
cooking. Store it in a clean, safe place (such as in its
packaging) away from sources of heat.
Silicone patch
Clean and dry before attaching to the temperature
sensor. Dishwasher safe.
Note: Cookware with the silicone patch must not be left
to soak for long periods in soapy water.
Temperature sensor window
The sensor window must always be clean and dry.
Proceed as follows:
▯
Remove dirt and oil splatters regularly.
▯
Use a soft cloth or cotton buds and window cleaner
for cleaning.
Notes
– Do not use abrasive cleaning agents such as
scouring pads, scrubbing brushes or cream
cleaners.
– Do not touch the sensor window with your fingers.
This may make it dirty or scratch it.
Changing the battery
If the temperature sensor does not light up when the
symbol is pressed, the battery is flat.
Changing the battery:
1 Remove the silicone cover from the lower section of
the temperature sensor housing and remove both
screws using a screwdriver.