Gaggenau CV 282, Инструкция по эксплуатации

Страница: 22 / 64

22
en
Transfer function
u
Transfer function
Transfer function
You can use this function to transfer the settings of one
hotplate to another.
This function can also be used on the flexible cooking
zones.
Note: You can find additional information on the correct
positioning of cookware in the section entitled
~
"Flex
function" on page 21
.
1 Remove any cookware from the hob.
The hotplate indicator will start flashing. The
hotplate is not heating up.
2 Set the cookware down on a flexible hotplate within
the next 90
seconds. The new hotplate will be
detected and the
ˆ
symbol will light up. The
applied heat setting will flash in the hotplate
display.
3 Use the twist knob to select the new hotplate within
90
seconds. The setting has been transferred.
Notes
– Move the cookware to a hotplate that is not
switched on, which has not yet been preset and on
which no other cookware has yet been placed.
– If the Flex function is activated by moving an item of
cookware across the flexible cooking zone, the
settings will be automatically applied.
– A set cooking time or the cooking sensor function
will also be transferred to the new hotplate. The
frying sensor function will not be transferred.
– The booster functions can only be moved from left
to right or from right to left when none of the
hotplates are active.
– If a new item of cookware is set down on another
hotplate before the settings have been confirmed,
this function will be ready for both pieces of
cookware. Confirm the desired hotplate.
– If more than one piece of cookware is moved, the
function will only be ready for the piece of
cookware that was moved last.
– During the adjustment time, you can return the
cookware to the original hotplate. The hotplate then
continues to heat up using the previous setting,
without the need for confirmation.
X|
Y| [|
\|
Z|
X|
Y| [|
\|
Å
Z|