Gaggenau CI 491 602, Инструкция по использованию и уходу

Страница: 24 / 80

24
Troubleshooting
If you encounter a problem, it often will merely be
something minor. Before you call customer service,
consider the suggestions and instructions below :
9
CAUTION
Repairs should only be done by a trained
servicer.
Improper repair of your appliance may result in
risk of severe physical injury or death.
Error messages
Fault Possible cause Measure
Cooktop is not working The electric power supply has been
interrupted. Use other electrical appliances to check if there has
been a power outage. Check to see if there is a prob-
lem with the circuit breaker for the electrical installa-
tion.
The appliance has not been correctly
connected following the connection dia-
gram. Make sure that the appliance has been connected cor-
rectly.
Electronic system malfunction. Contact the Technical Assistance Service.
The cooktop turns off by
itself The main switch has been touched unin-
tentionally. Press the main switch again. Reset the cooktop.
The display flashes (no
power) when you place a
pan on an induction ele-
ment The pan is not ferromagnetic Check the bottom of the pan with a magnet.
The diameter of the pan is to small. Use a pan with an appropriate diameter for the ele-
ment.
If the display still does not light up when you turn the
element off and on again, disconnect the appliance at
the circuit breaker. Wait 20 seconds and then recon-
nect it.
The Powerboost function
display flashes and then
turns off The element is too hot. The Powerboost function operates the element with
the highest possible power. During long cooking
times, it is possible that the function will turn the ele-
ment off to protect the cooktop from overheating. You
can continue to use the cooktop if the display is not
flashing.
Display
“
and numbers A fault in the electronic system has
occurred. Turn the appliance off and back on at the fuse or cir-
cuit breaker. If the same fault occurs again, discon-
nect the appliance and call Technical Assistance
Service.
Display
”
and numbers A fault has been detected. The following table of error messages lists actions you
can take to correct the problem
Indicator Malfunction Solution
Ҥ
+ number
š
+ number /
¡
+ number
Electronic system malfunction. Unplug the cooktop from the mains. Wait for 30 seconds and
switch it on again. If the warning persists, contact the technical
assistance service.
”‹
/
”Š
There is an internal error in the opera-
tion. Unplug the cooktop from the mains. Wait about 30 seconds
before plugging it in again. If the warning persists, contact the
technical assistance service.
•
The electronic system has overheated
and the corresponding element has
been switched off. Wait until the electronic system has cooled down completely.
Then push any symbol on the cooktop. If the warning persists,
contact the technical assistance service.
”…
The electronic system has overheated
and all elements have been switched off. Wait until the electronic system has cooleddown completely. Then
push any symbol on the cooktop. If the warningpersists, contact
the technical assistance service.
Do not place hot pans on the control panel.