13
Operating the appliance
Cooking compartment
The cooking compartment has four shelf positions.
The shelf positions are counted from the bottom up.
Caution!
–
Do not place anything on the cooking
compartment floor. Do not cover it with aluminium
foil. A build-up of heat could damage the
appliance.
–
Do not slide any accessories between the shelf
positions, or they may tip.
Always fully open the appliance door to the stop. In
this position, the open door will not swing back by
itself.
Inserting accessories
The accessories are equipped with a locking function.
The locking function prevents the accessories from
tilting when they are pulled out. The accessories must
be inserted into the cooking compartment correctly
for the tilt protection to work properly.
When inserting the wire rack, check
▯
that the lug (a) is pointing downwards
▯
that the safety bar on the wire rack is at the back
and facing upwards.
Switching on
1
Set the required heating mode using the function
selector. The chosen heating mode and the
default temperature are displayed.
2
If you want to change the default temperature:
set the required temperature with the rotary
selector.
The preheating symbol
“
appears on the display.
The bar continuously shows the preheating status.
When the set temperature is reached, a signal sounds
and the preheating symbol
“
goes off.
Note:
The oven interior lighting stays switched off at a
temperature setting below 70°C
Switching off:
Turn the function selector to
0
.
Rapid heating
The "Rapid heating" function brings your appliance to
the desired temperature quickly.
To ensure an even cooking result, only put your food in
the cooking compartment when the "rapid heating"
phase is complete.
You must activate the "Rapid heating" function in the
basic settings (refer to the
Basic settings
section).
Safety shut-off
For your protection, the appliance is equipped with an
automatic safety shut-off. Any heating process is
switched off after 12 hours if the oven is not operated
in this time. A message appears in the display.
Exception:
The long-term timer has been programmed.
Confirm the message with
™
and set the function
selector to
0
, then the appliance can be operated
again as usual.
D
D
