Gaggenau AC270101, Инструкция по установке и эксплуатации

Страница: 34 / 132

34
en
Operating the appliance
If the sensor control responds too strongly or not
enough, it can be changed accordingly:
1 With the appliance switched off, press and hold the
#
and
r
buttons for approximately 3 seconds.
2 Press the
@
or
A
button to change the sensor
control setting.
3 Press and hold the
#
and
r
buttons for
approximately 3 seconds to save the setting or wait
for around 10 seconds until the setting is saved
automatically.
A signal tone will sound.
Note: Press the
#
button to cancel the setting.
Saturation display
If the grease filter or odour filter is saturated, the
corresponding LEDs will flash and a repeated signal
tone will sound after the appliance has been switched
off:
▯
Grease filter: LED 1 flashes
▯
Odour filter: LED 2 flashes
▯
Grease filter and odour filter: LEDs 1 and 2 flash
The grease filters should now be cleaned or the odour
filter needs to be replaced.
~
"Cleaning and
maintenance" on page 38
The saturation indicators can be reset while they are
flashing. To do this, press the
œ
button.
Settings for using the odour filter
1 When the appliance is switched off, press and hold
the
#
and
œ
buttons for approx. 3 seconds.
The LED for the currently active filter setting lights
up on the appliance.
2 Press the
@
button/
A
button until LED 2 for
circulating-air mode (filter cannot be regenerated)
lights up on the appliance.
3 Press the
@
button/
A
button until LED 3 for
circulating-air mode (filter can be regenerated)
lights up on the appliance.
4 Press the
@
button/
A
button until LED 1 on the
appliance for the electronic controller is switched
back to operation without the air recirculation filter.
5 Press and hold the
#
and
œ
buttons for approx.
3 seconds to save the setting or wait for around
10 seconds until the setting is saved automatically.
A signal tone will sound.
Note: Press the
#
button to cancel the setting.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the
B
button.
Setting the brightness
Press and hold the
B
button for approx. 1 second until
the required brightness is reached.
Note: Colour temperature settings are available in the
Home Connect app provided the appliance has this
function.
Button tone
Switching on or off
Note: Only button tones can be switched on and off.
Signal tones on the appliance cannot be switched off.
1 When the appliance is switched off, press and hold
the
#
and
A
buttons for approx. 3 seconds.
The LED in the currently selected setting lights up.
2 Press the
@
or
A
button to change the setting.
The button tones are switched on if LED 1 lights up
on the appliance.
The button tones are switched off if LED 2
lights up
on the appliance.
3 Press and hold the
#
and
A
buttons for approx.
3 seconds to save the setting or wait for around
10 seconds until the setting is saved automatically.
A signal tone will sound.
Note: Press the
#
button to cancel the setting.