46
en
K
General information
General information
The surfaces of the appliance are easily damaged.
Avoid damaging them during installation.
Electrical connection
m
Warning – Risk of electric shock!
It must always be possible to disconnect the appliance
from the power supply. If there is a fixed connection, an
all-pole isolating switch with a contact gap of at least
3 mm must be provided for the wiring. Only an
electrician may install the fixed connection.We
recommend installing a residual-current circuit breaker
(RCCB) in the appliance's power supply circuit.
m
Warning – Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do not
kink or pinch the connecting cable during installation.
The required connection data can be found on the
rating plate inside the appliance; remove the odour filter
to access this.
This appliance complies with the EC interference
suppression regulations.
The appliance must be disconnected from the power
supply whenever installation work is being carried out.
When the appliance is installed, protection must be
provided against accidental contact in the future.
5
Installation
Installation
Preparing for installation
▯
The cooking vapours are more difficult to draw in
the further away they are from the hob. We
recommend a distance of at least 700
mm and a
maximum of 1500
mm.
▯
So that cooking vapours are optimally drawn in,
install the extractor hood in the middle of the hob.
▯
The installation site must be easily accessible, so
that the appliance can be accessed freely for
servicing.
Checking the ceiling
▯
The ceiling must be flat, horizontal and adequately
load-bearing.
▯
The depth of the bore holes must be the same
length as the screws.
▯
The enclosed screws are suitable only for concrete
ceilings.
▯
The max. weight of the appliance is
40 kg
.
Notes
–
When fixing the appliance in place, a suitable
substructure is required that is securely fastened to
the concrete ceiling.
–
Do not fit the appliance directly onto plasterboard
(or similar lightweight materials) in a suspended
ceiling.
–
To ensure correct installation, you must use a
material which is sufficiently stable and suitable for
both the structural conditions and the weight of the
appliance.
Preparing the ceiling
1
Cover the hob to protect it from damage.
2
Determine the position of the frame. In doing so,
determine where the middle should be based on the
hob.
3
Measure and mark the positions of the fastening
screws.
4
Drill four holes with a diameter of 6
mm for the
fixing.
Caution!
Ensure that there are no electrical wires, gas pipes
or water pipes in the area where holes are to be
drilled.
5
Screw the fastening screws into the ceiling.
6
Screw in the threaded rods.
