Gage CompuScope 14100C, Руководство по аппаратному обеспечению и инструкция по установке драйверов

Страница: 168 / 174

162 CompuScope 3200C
CompuScope 3200C connectors and headers
The CompuScope 3200C accepts digital data using a connector designed specially for ultra-fast digital signal
transmission.
A Trigger Out signal is also available on a BNC connector in order to synchronize the CS3200C to the rest of the
test system. The connectors and headers on the CS3200C card are shown below:
Figure 92: Connectors on CS3200C
•
Digital input MDR: this connector is used to input up to 32 bits of single-ended or differential digital
data lines, one clock input and one trigger input, all with 50
Ω
characteristic impedance.
This connector is designed to provide “equivalent to coax” performance by using copper conductors
encapsulated in a specially formulated Teflon to provide the appropriate dielectric constant. This
assembly is wrapped in a pleated copper foil, resulting in a 50
Ω
transmission line impedance for each of
the 68 conductors in the cable.
For more information on the technology used in this connector, please visit
www.mmm.com .
•
Trigger Out BNC: this connector is used to output a 0 to 5 Volt, TTL signal which signifies that a
trigger event has occurred on the CS3200C.
•
Clock Out BNC: In some select cases, a user may want to drive the rest of the test system with the
internal clock of the CS3200C. A 5 Volt CMOS clock signal capable of driving a 50
Ω
load is available
on the card as a standard feature for this purpose.