20
Governors America Corp. © 2021 Copyright All Rights Reserved
Enhanced Electronic Governor EEG7000 with GAConfig Tool 8-2021-D6
PIB1009
ADDITIONAl EEG7000 CAPABIlITIES
16
light force Governing
provides finer adjustment resolution for smaller actuators. It is designed to work with low current small actuators,
like T1 ATB, ALR/ALN, 100/103/104 series and normally closed Cummins EFC actuators. Select Light Force Governing from the Engine
Tuning
Tuning menu when using small actuators to improve adjustments as they respond very quickly to input changes over a smaller
range of operating current, using a fraction of the PID and current output of a normal actuator.
lead circuit
(default is ON) enables the speed controller to be more responsive and typically increases the range of gain adjustment.
This function allows for more active control to increase the performance in typically slow engines.
idle
is set with Speed 1 of the speed control settings on the Engine Tuning menu.
Smoke reduction
is an adjustment made using the Start Fuel parameter in the Engine Tuning menu. This sets the actuator % applied
during crank in order to start easily but not too high to reduce black smoke.
auxiliary enable
enables connections to synchronizing and load sharing equipment. This allows the adjustment of the speed requests
through the auxiliary input voltage, accepting a 1 - 9 V DC signal, biased at 5 V, and selectable response polarity. In response the
EEG7000 will increase or decrease voltage but does not change engine speed.
can
j1939
bus device communication is supported to receive and display J1939 messages.
imPortinG, exPortinG, anD reStorinG SettinGS
The EEG7000 offers a number of GAC specific capabilities as well as helpful tools.
The GAConfig Tool allows settings in the tool to be stored, shared,
and imported back into the tool for use on multiple EEG7000 con-
trollers. Export settings at any time while using the GAConfig Tool.
To export files
:
1.
EEG7000 must be powered on and connected to the GAConfig Tool.
2.
At the Tool bar click the Export button. The Save as dialog allows you to select the location you want to save the file.
To import files
:
1.
EEG7000 must be turned on and connected to the GAConfig Tool.
2.
At the Tool bar click the Import button. The Save as dialog allows you to select the location you want to save the file.
Best practice is to export engine settings information once the engine performs as desired. Name the file using dates and intended use
as part of the file name. These files are helpful when shared with the GAC support team to aid further enhancing your settings.
to restore the original Gac factory settings:
1.
Shut the engine off. Factory restore can be done when the engine is off but the GAConfig Tool is running.
2.
Access the Quick Configuration
Advanced Configuration
System Commands menu.
3. Click Factory Restore to set the EEG7000 to its factory settings. GAC factory settings are not the same settings used on an OEM
version of the EEG7000.
4. To reset just the software settings, click System Reset.
Parameter settings can be created before connecting to the engine and uploaded once the connection is made. The EEG7000 must be
connected to power and the PC.
1.
Click the Connect button on the Main menu. The Import Configuration menu displays asking if you want to import the settings you
have recently created.
2. Click Import to update the EEG7000. The progress bar displays. If the controller is not ready or not connected they system displays
an error message.
offline Set UP moDe
