Warning!
Make sure the concrete wall is solid
and at least 8 inches (20 cm) thick. If the
concrete exhibits cracks or other defects, this
may result in failure of the concrete anchors
and cause serious personal injury or damage to
your display.
1.
Place the wall bracket template up to the
marked locations, and tape it to the wall.
Use the provided bubble level to make sure
the template is level before drilling. Use a
pencil to mark the two locations as shown,
and place a piece of tape over each mark.
2.
Use a 3/8-inch (10 mm) concrete drill bit to predrill
the marked spots 2.4 inches (60 mm) deep, and
then clean out the debris from the holes.
13
Mounting the Display on
the Wall Bracket
Important!
We recommend that two
people perform this step.
1.
Lift your display up to the wall
bracket, and seat the display
mounting plate’s flanges into
the wall bracket’s flanges.
3.
Remove the template and Insert the concrete
anchors into the predrilled holes, and use a
hammer to tap the anchors into the concrete.
4.
Attach the bracket to the wall by inserting the
anchor screws through the washers and the
wall bracket’s mounting holes, and screw them
into the anchors until secure. Do not overtighten
the screws.
