G-Tek LmNet - PRO 614-00, Руководство по эксплуатации

Страница: 22 / 53

G-Tek Corporation Private Limited 21
O
PERATION
After the proper wiring is done, power on the LmNet. The display will show “G - Tek Corporation”.
Following this, the parameter values of RTC, Temperature & RH, channel 1 to 4 displayed on LED
display one by one in sequence. To start the storage, user must start the batch on the LmNet. If the
batch is previously running and is not stopped, then after power up the batch will continue to run, and
storage will resume. User can reconfigure the parameters here by going into programming menu
(Refer Programming section).
Figure 19 key function
FUNCTION
KEY
UP
KEY DOWN
KEY
ENTER
KEY
BACK
KEY
ALL LED INDICATION