G-Tech GL-6000L Series, Руководство по обслуживанию

Страница: 13 / 36

13
5 Gravity Acceleration Setting Mode
5.1 How to Enter Gravity Acceleration Setting Mode
: Press " On/Off " Key to turn on the power and press “ ZERO ” Key until the booting is
completed to show "CAL4" on the display and enter Gravity Acceleration Mode.
- ZERO Key: Add 1 to the flickering digit
- TARE Key: Move the flickering digit to the left
- PRINT Key: Save the settings and enter Measurement Mode
* The gravity constant compensation function is not set at the factory. To use this function,
you must separately set the gravity constant value and calibrate it.
6 General Setting Mode
6.1 How to Enter General Setting Mode
: Press "ON/OFF" Key to turn on the power and press “ZERO” and “TARE” Keys until the
booting is completed to show "p-zero" on the display and enter General Setting Mode. Use
below Keys to change settings.
- UNIT Key: Change setting type and setting value.
- TARE Key: Select settings
Description of General Setting Mode
Type Initial Value Setting Value Description
p-zero
3
It sets the range of initial zero point.
(e.g.) When the setting value is set 10, it means to be
within ±10% of capacity.
5
● 10
20
30
40
50
100
Type Initial Value Setting Value Description
z-rang
● 2
It sets the range of zero key function.
(e.g.) When the setting value is set 2, it means to be
within ±2% of capacity.
3
4
10
20