FW Murphy TDXM-DC Series, Инструкция по установке и эксплуатации

Страница: 6 / 20

Section 10 00-02-0511
2019-07-10 2
TDXM-DC Mounting
Warning: Turn the power source off before mounting the TDXM-DC.
The TDXM-DC Series module was designed to be mounted within a weatherproof enclosure and is intended for
mounting in a flat panel.
1. Precut a square mounting hole of 5.5 in. (140 mm) and four mounting holes 0.25 in. (6.35 mm) dia., see
diagram.
2. Align the mounting studs to the drilled holes and insert the TDXM-DC from the front side of the panel.
3. Place a washer and a nut on each stud.
4. Equally tighten the nuts using an X-Pattern. The maximum torque is 9 in. lbs. Do not overtighten.
Dimensions
NOTE: The TDXM controller and TDXM-DC are the same product. The controller shows TDXM only.
IMPORTANT: For outdoor use, mount the TDXM-DC controller in a weatherproof enclosure.