Original User Manual FUXTEC 20V cordless angle grinder FX-E1WS20
9
Figure 2: Bottom side of battery angle grinder
To attach the protective shield (item 7) to the unit, open the mounting lever (item 9) provided and
then slide the shield over the drive spindle (item 11) to the desired position. Close the lever again to
fasten the shield. Make sure that all the lugs of the fixing lever sink into the notches provided in the
shield.
Position the protective shield so that you as the user are protected from any sparks. To change the
position of the shield, you must always open the fastening lever.
Use
This power tool is intended as a grinder, sander, wire brush or cutting tool for private use. Please
read these operating instructions carefully. Failure to follow instructions may result in electric shock,
fire and/or cause serious injury.
Polishing with this machine is not recommended. Any work that is not in accordance with the
intended purpose is dangerous and can cause personal injury.
Do not use accessories that are not recommended by FUXTEC.
The rated speed of the accessories to be used must be the same as the rated speed of the device
used. Accessories that can run faster than the rated speed of the device may break apart during use
and cause serious damage.
The outer diameter and thickness of the accessories must be within the capacity limits of the device.
Incorrectly dimensioned accessories cannot be used safely.
The threads of the accessories must match those of the grinding spindle thread. Unsuitable
accessories can lead to loss of control and serious damage.
A kickback is a sudden reaction to a tangled or jammed rotating disc, backing pad, brush or other
accessories.
