USER GUIDE |
USB BACKUP HSM
Page
9
of 31
You can change the User PIN by doing the following:
1. Unlock the USB Backup HSM with the User PIN. The
green
LED will blink.
2. Press the
+ 1 buttons together for five seconds. The
red
LED will blink.
3. Enter the current User PIN and press the
button. The
blue
LED will glow solidly and the
green
LED
will blink.
4. Enter the new User PIN and press the
button. The
green
LED will blink three times, followed by the
blue
LED glowing solidly and the
green
LED blinking.
5. Re-enter the new User PIN and press the
button. The
green
LED will glow solidly for a second or two,
then will return to the User mode, indicated by the
green
LED blinking.
[4.4] DELETING THE USER PIN
Delete the User PIN by doing the following:
1. Enter the Admin mode by holding
+ 0 for five seconds. With the
red
LED blinking, enter the Admin
PIN and press the
button; the
blue
LED will now glow solidly.
2. Press the 7 + 8 buttons together for five seconds. The
green
LED will blink three times and then will be
followed by the
red
and
blue
LEDs blinking alternately.
3. Press the 7 + 8 buttons together again for five seconds. The
green
LED will glow solidly for a second or
two.
4. The key will return to Admin mode indicated by the
blue
LED glowing solidly.
NOTE: Deleting the User PIN will also delete the "Self-Destruct PIN" on the next page as well as all recovery
PINs (if any have been set).