00050064.DOC, Version 1.1
27/27
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
120-240 V AC, 50/60 Hz ~
Power consumption:
115 W
Protection grade:
IP 65
Beam angle:
approx. 40°
Number of LEDs:
72
DMX-control-channels:
2/5
DMX-512-connection:
5-pin screw connector
Flash-rate:
18 Hz
Dimensions (LxWxH):
200 x 345 x 380 mm
Weight:
11 kg
Maximum ambient temperature T
a
:
45° C
Maximum housing temperature T
B
(steady state):
65° C
Min.distance from flammable surfaces:
0.1 m
Min.distance to lighted object:
0.1 m
Accessory:
FUTURELIGHT PEC-03 for LED OFL Series
No. 51841386
FUTURELIGHT SEC-03 for LED OFL Series
No. 51841385
FUTURELIGHT CP-240 controller
No. 51834265
FUTURELIGHT CP-256/64 controller 16bit
No. 51834288
FUTURELIGHT CP-512/64 controller 16bit
No. 51834295
Wizard-512 USB DMX-So Interface
No. 51860102
Wizard-1024 USB DMX-So Interface
No. 51860110
FUTURELIGHT DES-3 DMX-terminator 3-pin
No. 51834001
Please note: Every information is subject to change without prior notice. 25.01.2010 ©
