Future Design MCT-CM, Руководство пользователя

Страница: 69 / 247

MCT-CM
69
For example, if digital output 1 is used as a control output to turn on a circulating fan that are common to both
system 1 and system 2 when a system event is turned on, then select digital output 1 from the list. This will
enable the redundancy logic whenever the circulating fans are on. Additional outputs can be selected if
necessary.
Once all selections have been made, press the ‘Done’ button to accept the output selections and
return to the Redundancy Setup screen.
4.7 Functions
The MCT functions are accessed from the
“Startup” menu and allow the OEM to select which screens/menu
items will be enabled (shown) in the MCT runtime application. These functions can be used to customize the
system to meet specific requirements.
When functions are disabled at the configurator level from the
Functions list, it will be disabled in the runtime
software by removing the menu item so the operator cannot select the function or edit any corresponding
settings related to the function. The following list shows the available MCT functions, where to find the menu
item(s) applicable to the function and a description of what it applies to.
IMPORTANT: Disabling MCT functions that are not required for the application results in a system that is
clean and easy to use for the operator; however, be careful when disabling certain items.
Without access to them, there will be no way of determining if the system is operating as
required, i.e., wait for conditions programmed in an automatic program already loaded, but no
way of accessing them because the Wait For access has been revoked. The program may
then enter a wait for condition that the operator did not know about and think the system is
malfunctioning.