Future Design MCT-CM, Руководство пользователя

Страница: 63 / 247

MCT-CM
63
Connecting to the MCT Process Monitor Modules for more information on the proper DIP switch
settings pertaining to the type of monitor card used.
The card type drop-down menu
is used to select the type of monitor module connected to the MCT. Available
selections are Not Used, Analog, RTD and Thermocouple.
The input type drop-down menu is shown only for RTD and Thermocouple type monitor input modules. This
field is used to select from one of the available sensor types that are supported by the input module. The analog
input modules have fixed voltage or current input ranges. The available RTD and Thermocouple input ranges
are provided in the following tables.
RTD Selections Thermocouple Selections
Sensor Type Input range Sensor Type Input Range
PT100 -200 to 850°C + 0.3°C Type J -150 to 760°C + 0.2°C
Ni120 -80 to 320°C + 0.3°C Type K -200 to 1370°C + 0.3°C
PT1000 -200 to 850°C + 0.3°C Type E -0 to 600°C + 0.1°C
Ni1000-DIN -200 to 850°C + 0.3°C Type T -200 to 400°C + 0.3°C
Ni1000-Landys&Gyr -200 to 850°C + 0.3°C Type N 0 to 1300°C + 0.3°C
10-400ohms 10 to 400 Type B 400 to 18200°C + 0.5°C
10-4000ohms 10 to 4000 Type S -50 to 1767°C + 0.6°C
Type R -50 to 1767°C + 0.7°C
0
– 50mV
0 to 50 + 0.1%
Type C 0 to 2315.5°C + 0.7°C
Type D 0 to 2315.5°C + 0.7°C
Type G 0 to 2315.5°C + 0.9°C
-100
– 100mV
-100 to 100 + 0.1%
The
Line Frequency Compensation field is shown if one or both monitor input cards are configured for use.
It is used to set the filtering circuit in the monitor input modules. The field has an adjustable range from 50 to
60 corresponding to typical 50Hz and 60Hz power sources.
4.4 Event Setup
The
“Event Setup” screen allows the OEM to assign specific digital outputs to each system event. Outputs can
be assigned to one or more events as required based on the application.