Page 5 of 5 // email [email protected] US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577
Configuration
IR
RS232
Action
Comments
STORE
OUT
Set maximum
telescope height
Stores current telescope height
STORE
STOP
OUT
Clear maximum
telescope height
Reverts to physical limit of
telescope
STORE
PRESET
Set intermediate
viewing angle
“PRESET”
Stores current swivel position
STORE
A
Set intermediate
viewing angle “A”
Stores current swivel position
STORE
B
Set intermediate
viewing angle “B”
Stores current swivel position
STORE
C
Set intermediate
viewing angle “C”
Stores current swivel position
STORE
<
Set maximum left
rotation
Stores current swivel position
STORE
>
Set maximum right
rotation
Stores current swivel position
STORE
STOP
<
Clear maximum left
rotation
Reverts to 180 degree rotation to
the left
STORE
STOP
>
Clear maximum
right rotation
Reverts to 180 degree rotation to
the right
STORE
STORE
HOME
Factory Reset
Telescope height and viewing
angles must be reconfigured
after performing a factory reset
STORE
STORE
>
Swivel recovery
See above
Contact Closure available on request
The standard Under Bed Lift control unit does not provide direct contact closure control. A separate
external module is available upon request providing Contact Closure to RS232 conversion, allowing
switched control of all UBL models.