Inductive Charging System
ICS LF-01
Li-FePO4 battery inductive charger for T7PX(R) / T4PV / T4PM
Notes:
Before using your new LF-01, please read this manual thoroughly and use it properly
and safely. After reading this manual, store it in a safe place.
Thank you for purchasing an ICS LF-01. This product is a battery
charger designed for use only with the Li-FePO4 polymer battery
in the T7PX(R), T4PV or T4PM. In order to get high performance
of the product and use it safely, please read this instruction manual
thoroughly before use.
· ©Copyright 2018. No part of this manual may be reproduced in any form without prior permission.
· The contents of this manual are subject to change without prior notice.
· While this manual has been carefully written, there may be inadvertent errors or omissions. Please contact our
service center if you feel that any corrections or clarifications should be made.
· Futaba is not responsible for the use of this product by the customer.
1M23N34004
Safety Precautions
Safety Precautions
Set Contents
Set Contents
Please observe the following precautions to ensure safe use of this product at all times.
After opening the bag, first check if the contents conform to the following. The contents depend on the set as
shown below.
Meaning of Special Markings:
The parts of this manual indicated by the following marks require special attention from the standpoint of
safety.
: Prohibited
Symbols:
: Mandatory
DANGER
Procedures which may have a high
risk of death/serious injury to the
user if not carried out properly.
WARNING
Procedures which may lead to a
dangerous condition or cause death
or serious injury to the user if not
carried out properly, or procedures
where the probability of superficial
injury or physical damage is high.
CAUTION
Procedures where the possibility of
serious injury to the user is small,
but there is a danger of injury, or
physical damage, if not carried out
properly.
Usable Transmitter
Usable Battery
T7PX(R) / T4PV / T4PM
FT2F1700B / FT2F1700BV2 / FT2F1100B
*FT2F2100B / FT2F2100BV2 are not supported because it is over dimension.
*As of February 2020
*The T3PV / T4PX can be used by using a double extension cable.
(The specifications are subject to change without prior notice due to the technical development.)
Specifications
Rechargeable battery: Li-FePO4 polymer battery / 2S type
Input: DC11.4 ~12.6V / Output current: 0.7A
Operating temperature: -10
°
C ~ +40
°
C (10
°
C~ +30
°
C is recommended)
Storage temperature: -20
°
C ~ +60
°
C (0
°
C ~ +30
°
C is recommended)
Dimensions:Tx 160 x 72 x 24 mm / Rx 138 x 70 x 17 mm
Weight: Tx 99 g / Rx 44.5 g
●This product cannot be repaired because it is designed to not be disassembled for safety reasons.
●If you have questions about this product, please contact your Futaba dealer.
Usage Precautions
Usage Precautions
[LiFe Battery]
▪The battery at the time of purchase:
Since the battery is not charged at the factory, please charge it before use. Also, whenever the battery has not
been used for a long period of time, recharge it before use.
▪LiFe battery will be damaged if it over-discharges.:
When over-discharging is carried out and low voltage, it becomes impossible to charge. It is important to charge
a battery periodically.
▪Operating temperatures:
The further the temperature goes down, the more the operating time shortens. When you use the battery at low
temperatures, it is recommended to have another charged battery as a backup.
▪Carry and storage:
Do not leave the battery in the battery charger or the equipment when stored. Even when the power switch is
off, a small amount of electricity continues to leak out of the battery and may lead to the decrease in battery
performance. If you do not use the battery, store it in a cool and dry place with a temperature between 15 ˚C ~25
˚C.
When you carry or store the battery, prevent the short-circuiting of the +/- terminals. Do not put any metallic
objects including personal ornaments in a bag or drawer with the battery. This could cause a fire, overheating,
explosion or the leakage of electrolyte fluid.
▪Service life:
Battery performance degrades gradually after repeated charging and discharging. If the operating time of the
battery decreases significantly, it may be the time to replace it with a new one.
[Precautions in Handling the Battery Charger]
▪Before use:
Please read the safety precautions thoroughly before use, and follow the instructions for operation.
▪
Precautions for use:
The optimum ambient temperature for charging is between 10 ˚C ~30 ˚C.
When the battery is hot, as is the case shortly after use, recharging may not be performed properly. Wait until the
battery temperature goes down. The battery charger and the battery get warm during charging. However, it is not
a malfunction.
TV or radio reception may interfere with the charging performance. However, this is not a malfunction, either. To
avoid interference, move the battery charger away from the TV or radio.
▪How to take care of the
battery charger:
Remove stains from the battery charger by wiping it with a dry and soft cloth. Do not use a wet cloth, alcohol,
thinner, benzene or detergent.
- 1 -
Instruction
Manual
FUTABA CORPORATION
oak kandakajicho 8F 3-4 Kandakajicho, Chiyoda-ku, Tokyo 101-0045, Japan
TEL: +81-3-4316-4820, FAX: +81-3-4316-4823
©FUTABA CORPORATION 2020, 02 (2)
Charger Tx side
(Charging stand)
Charger Rx side
Power cable
