FUTABA 3pv-2.4g, Инструкция по эксплуатации

Страница: 16 / 23

16
3PV-2.4G Functions
Model Selection
／
Model Reset
（
MDL
）
Low Battery Alarm
（
LBA
）
System Type
（
SYS
）
The model selection selects the desired model memory from the 10 model memories stored
within the transmitter, and the model reset erases all data stored in a specific model memory.
Model Name
（
MDL NAME
）
Model number
（
1 - 0
）
Model name
Model Reset
Push the DT1 lever right or left
for about two seconds.
All data stored in the currently
selected model memory is
erased.
Model Selection
Selection key
T h i s f u n c t i o n p r o v i d e s a
4-character name for each of the
model memories in the transmitter
to easily select the correct setup
for the model currently in use.
• Clearly label each model for easy
selection.
Select the battery alarm voltage
according to the battery to be used.
*The voltage drop of a rechargeable battery
and a dry cell battery is different. When
using a rechargeable battery, always change
the voltage.
System changes (T-FHSS, S-FHSS,
FHSS, T-FHSS <High-Speed>)
matched to the receiver type.
●
4 dry cell batteries
⇒
4.2V
●
HT5F1800B (5cell NiMH battery)
⇒
5.0V
●
FT2F1700BV2/FT2F2100BV2 (2cell LiFe battery)
⇒
5.8V
Model Name
(Selection)
Model number
（ 1 - 0 ）
Model name
(Selection key)
Low battery voltage
Alarm start voltage
Voltage change
System Type
TFH: T-FHSS
SFH: S-FHSS
FH: FHSS
TFH-HS: T-FHSS
＜
High-Speed
＞
System change
●
R314SB/R304SB
－
T-FHSS (TFH), T-FHSS High-Speed (TFH-HS) : The voltage of the receiver is shown to a transmitter.
●
R203GF
－－－
S-FHSS (SFH), FHSS (FH)
When using the T3PV in the T-FHSS High-Speed mode, always use it under the following conditions:
Servos :Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery can-
not be used).
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it
operates. In addition, it may cause servo trouble.
Power Switch: OFF
→
ON
When the system was changed and
when a model of a different system
was selected, signal are output in the
system set at the point at which the
transmitter power was turned back on.