WG-7302
Page
8
Document Details
WG-7302 User’s Guide
1 Introduction
This manual describes theWG-7302 boards made by FUSHENGTEK Technology. In this manual the boards will also
be denoted WG-7302-E38/J19.
The WG-7302 boards are based on Intel Atom E38xx/J19SoC (System on Chip) “Intel Bay Trail” and will be
available in three versions. The three types of boards are listed in this table:
Ordering Information
Article
Description
WG-7302-A10-X
Display: 1x LVDS+ 1x HDMI or 1x LVDS+ 1x VGA
WG-7302-A11-X
Display: 1x eDP+ 1x HDMI or 1x eDP+ 1x VGA
WG-7302-A12-X
Display: 2x HDMI or 1x VGA+1x HDMI
WG-7302W-A10-X
Display: 1x LVDS+ 1x HDMI or 1x LVDS+ 1x VGA
Temperature :-40°C to +85°C
WG-7302W-A11-X
Display: 1x eDP+ 1x HDMI or 1x eDP+ 1x VGA
Temperature :-40°C to +85°C
WG-7302W-A12-X
Display: 2x HDMI or 1x VGA+ 1x HDMI
Temperature:-40°C to +85°C
Note:
X-CPU model
，
CPU
：
E3805,E3815,E3825,E3826,E3827,E3845,J1900
Use of this Users Guide implies a basic knowledge of PC-AT hard- and software. This manual is focused on
describing the E38/J19 board’s special features and is not intended to be a standard PC-AT textbook.
New users are recommended to study the short installation procedure stated in the following chapter before
switching-on the power.
All configuration and setup of the CPU board is either done automatically or manually by the user via the BIOS setup
menus. Only exceptions are the “Clear CMOS” Jumper and the “Always On” jumper.
