Furuno WR2120, Руководство по установке

Страница: 16 / 73

10
2.2. Signal Processing Unit
Parameter Descriptions
Unit name WR2120-SPU
Data Output
*1
Rainfall intensity R (mm/h), Reflectivity factor Zh (dBZ),
Doppler velocity V (m/s), Differential reflectivity Zdr,
Specific differential phase Kdp (deg/km),
Cross polarization difference phase φdp (deg),
Co-polar correlation coefficient ρhv,
Doppler velocity spectrum width W (m/s)
Scan modes PPI, Volume scan, PPI/RHI (Sector Scan also availiable)
Ground clutter Rejection Enable
Data Correction
Distance attenuation, Rain attenuation, Excessive Doppler
velocity, Suppression of signal returns from lan, Clutter
suppression
Interface LAN 1 port, Ethernet 1000 Base-T (Cat5e STP or better)
Power supply 100 to 240VAC, Single Phase, 50/60 Hz
Power consumption Max. 650W include Antenna Unit
Rated Ampere 2.7 to 6.5 A
Size W756 mm × D300 mm × H750 mm
Weight 45 kg (99 lb.)
Operating Temperature range -10 to +50 °C
Storage Temperature range -40 to +70
°C
Water & Dust proof IP55
*1
:
Details are processing by the main unit.
Note:
There are two voltage types (100-130V / 200-250V) of Signal Processing Unit. It should be applied to
the local power voltage. Moreover, the user must select the voltage type that suit to the local power
voltage or else it will not activate.
The power supply label is attached inside SPU. (Refer to page ii,
POWER SUPPLY LABEL)