Furuno NAVpilot-300, Руководство оператора, Страница: 63 / 101

5. GESTURE CONTROLLER GC-001
5-5
5.5 GC-001 Alerts
Alerts are displayed one the GC-001 screen in the following circumstances:
• The GC-001 generates an alert.
• The GC-001 receives an alert generated by the processor unit.
Depending on your settings, the buzzer sounds and the GC-001 vibrates to inform you
of an alert. Press any key to silence the buzzer and stop the vibration; the alert mes-
sages shown on the GC-001 and the NAVpilot-300 are also closed.
When the GC-001 detects an alert condition, the alert icon remains until the reason for
the alert is removed. If the alert cause is present after three minutes, the alert buzzer
sounds again and the alert message reappears.
5.5.1 Alert priority
There are three levels of alert priority: [Alarm], [Warning] and [Caution] (see
chapter 3). If there is more than one alert active, the highest priority alert is displayed.
If an alert generated by the GC-001 is active at the same time as an alert received from
the processor unit, the GC-001 alert is displayed.
5.5.2 Alert list
Alerts generated by the GC-001
The table below list all alerts generated by the GC-001, along with their meaning, alert
level, priority in which they are displayed and possible remedy.
Display
Priority
Message Meaning/remedy
Alert level: Alarm
1 LOW BATTERY Remaining battery voltage is lower than 10%. Replace
the batteries referring to the User Guide included with
the GC-001.
2 COMM ERROR There is a communication problem between the GC-
001 and the processor unit. Check that the processor
unit is turned on.
NP300-RC
CAUTION
DEVIATION
ALERT.
Alert icon
Alert priority
Alert message